Question Locked

Installing win2k3 and configuring RAID on Dell Power edge 2850

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have dell poweredge 2850 machine having two 70 GB harddisks.i try to configure RAID 1 and install win2k3 operating system over it.As mentioned in docouments, i insert the " Dell installation and server management CD " and restart the machine.

the user guide and some other guides tells that it will ask for
language option, software licence. and then click SERVER SETUP on system managemnt page.

but when cd boots , it starts to boot isolinux then asks 3 options

1. server assistance
2. server assistance with media check
3 boot from hard disk

by default it goes on 1( server assistance )

...
..
to begin replication insert your replication floppy
replication will beging on system when the system is booted
..
...
at the end on monitor message appears as " no out of range"

However ever
I am expecting that CD will ask from me Language options,sw licence , server setup,and I will become capable to install window 2003 server with Raid 1 support but invain.

Also which option I have to select in system setup for

Integrated Devices
1. Embedded SCSI Controller
2. Embedded RAID Controller
3. off

Kindly guide me where i am wrong .
Also tell me if want to configure RAID 1 after installation of win2k3 , then how can I

3 replies

by chillitogo

I am having similar problem with Dell Power edge 1750 server.

I went on to Dell.com and didn?t found any solutions.

The CD that I am using is Open Manage Version 5.0.

I also tried to use Versions - 3.1, 4.5, and 5.3 and none of them worked.

Did you happens to found a solution for this problem?

If you did, can you please share it with me?

by sambakamba

Hello There,

I have similar issue...

trying to configure raid1 on already installed win 2k3 server.

Any advuse

This discussion is closed to new replies.