In general, the device to connect client devices to the WLAN are known as access points.
An access point has two interfaces. In the beginning these were:
LAN side.......Client Side
Ethernet ---- 802.11b
then some vendors created Access Points that could use WiFi for the LAN side as well. To confuse things, these are somewhat similar to the concept of a WLAN bridge:
e.g.
LAN side.......Client Side
802.11b ---- 802.11b
Fast forward a few years, and we get new technologies that are better and faster for the LAN side connection, such as 802.11a WLAN, offering a higher data rate at 5.4GHZ
e.g.
LAN side.......Client Side
802.11a ---- 802.11b
Now keep in mind that 802.11a or 802.11b are mostly used for short-range (~100 meter) connectivity.
How then, would we hook up an Access Point to give WiFi to those in the town square?
Well, you could setup a DSL circuit:
LAN side ----- Client side
DSL-Ethernet ------802.11b
But that's costly and you need to run wires, so the next steps are:
LAN side ----- Client side
GSM or HSPDA ----- 802.11b / g
Better, but GSM typically gives 1MBs at fairly high cost
The promised LAN:
LAN side ------------ Client side
WiMax (IEEE 802.16) ------ 802.11b/g
This gives the best of all worlds, as WiMax offers a speed faster than the DSL circuit, often 128MBS, with the convenience of GSM.
http://en.wikipedia.org/wiki/WiMAX
The whole 'mesh' concept is just how all these APs are hooked together and talk to each other.
http://en.wikipedia.org/wiki/Wireless_mesh_network
Remember WiMax is a carrier technology, like GSM or HSPDA. WLAN/WiFi is a LAN ethernet replacement.