Question Locked

Microsoft RRAS + Successful Ping But No Response From Resources

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

First off, sorry for the double post in (discussions).

Hi, was hoping someone would be able to help me out here. I?ve setup a system on the network for RRAS. It has both an external and internal IP address assigned to separate NIC?s. I ran through the Configuration and Enable Routing and Remote Access, setting up a PPTP VPN. So far everything has been successful. I can authenticate and log onto the network remotely, authentication is done via a domain controller. When I ping any of the internal network hosts from my remote client I can get a response. However when I attempt to access any resources wither it be a windows share, or the network intranet site I get no response. Permissions are correctly set for the windows share, and I have tried access both using their FQDN, and local IP addresses.

After this happened I then attempted to connect to the intranet site directly using a telnet session on port 80. It appears a connection is established however no TCP/IP traffic seems to be getting returned to the client. Only ICMP (Ping request provide this).
Following this I checked the filter settings on the servers LAN NIC, there does not appear to be any filter settings set.

Any help on the matter would be appreciated, as I find it a little weird that I can connect to no problem, ping the systems within the network, yet not access any resources what so ever.

2 replies

This discussion is closed to new replies.