Discussion Locked

Mid Size Network

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can someone give me an example of the hardware used in an average mid sized Windows network. If possible can you please include an example network diagram.

Thanks
Rob

7 replies

by hsebai

A lot of information is needed as follows:

1- how mmany users ?

2- distribution of users, i.e single floor, multiple floors, two buildings, several buildings, etc.... in other words your organization layout (building layout.

3- do you need network management?

4- how many servers existing and your future planning?

5- what speed you wish end users to have, and for the servers.

6- do you need security?

7- Is there any remote users?

8- Is redundancy is imp (high availablity)?

by rarnold

1- Roughly 150 - 250 users
2 - multiple subnets, most likely 3
3 - yes
4 - Currently 5 servers, may add more
5 - Speed will be 100mb
6 - We are using Cisco Pix for security
7 - We have a VPN for remote users

by meganetcomputers

How is the network going to be set up (over a couple of floors, building, cities?). Is it going to be orginized by group like accounting, sales, and so on? With some of these other questions answered you can pick out your hardware and configure yournetwork. This type of network should be based on the 3 tier architecture. Where you have the core, distribution and access. The core would be the back one where you would connect your T-1 too. Then you will have your distribution layer where it passes the information to the access layer where the workstations are.

by hsebai

Please try to be more specific, 3 subnets may be in single floor and or multiple floors, I shall take your answer that the users spans 3 floors with average users 70 User per floor.

I disgree with the answer that you should have 3 tier arch., asnumber of users is not too many for one thing and the other, this kind of arch. is costy somehow, so if you are tight on budget, you should consider another approch.
3 tier Arch. is must if there will be Qos required and I don't know if this will be your case.
lets consider the following till you get back with more specfic answers:
1- You will need a backbone with layer 3, non-blocking arch. with 9 gigabit ports (1000Base-X or 1000Bast-T) for edge switches (to connect end users), and 5 ports gigabit 1000Base-T for servers with switching capacity at least 32Gbps and forward rate not less than 24Mpps (I have considered 4 additional ports for future expansion.
2- 9 Edge switches 24-Port, 3 per floor, Each edge switch will have direct connection to the backbone, non-blocking Arch with switching capacity not less than 8.8Gbps and forward rate not less than 6Mpps.
You should consider 3Com 4900SX or 4900 as backbone, and 3Com 4400 for Edge.
3- choose 4900Sx or 4900 depends upon how edge switch will be linked to the backbone( Via fiber or UTP).
4- you also stack the edge switches togather for each floor and this approch you can degrease the number of gigbit ports required on the backbone switch, if you stack switches togather, you can have dual links to the stack (will act like redundant link)or trunk the uplinks (only available in 3Com (trunking across stack) and you can consdider connecting the router or PIX to the backbone switch
There are several possible configuration, and alternatives, and above approch is fast, reliable, and dose not cost too much, but lacks redundancy, high availablity.

This discussion is closed to new replies.