Discussion Locked

Moving ARCserve 6.5 DB - Any gotcha's?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I currently have ARCserve 6.5 installed on the C drive (Boot partition) of my NT4 (SP6) server. I'm receiving "getting FULL" type messages from the server primarily due to the size of the ARCserve DB. I would like to relocate the entire app/service or just the database to another drive/partition. You can understand my anxiety in doing so.
Has anybody successfully done this? Were there any hangup's? Did you run into any glitches? LOOKING FOR EXPERIENCED ADVICE

3 replies

by dwilcox22

Make a copy of the DB and uninstall ARCserv. Do a new installation pointing to a different drive. After the installation replace the newly created dB with the older dB.
That should work fine.

This discussion is closed to new replies.