5 replies
You are on the right track. A MUX on each end will allow you to channelize the fiber into usable bandwidth. You will probably want to connect the fiber to a T3 interface, peel off as many T1 or DS0 channels as you need for voice, and use the remaining bandwidth for data.
Check out http://www.adtran.com for product information.
The equipment you need will have a T3 fiber interface on one side and multiple serial, high-speed serial, or ethernet interfaces on the other side. There aren't many manufacturers building MUX's with ethernet interfaces built in so, your final configuration will have a MUX on each end of the fiber, a serial port on the MUX connecting a T1 to your telephone equipment, and a high-speed serial port connecting the remaining bandwidth to a router. From the router, you will peel off ethernet to connect to your LAN.
by airforce1
by ntoz
In order to give better advice to this question, important things like, what do you use for routing today? Cisco makes a good solution for what your trying to do. What your looking for perhaps is anything based on the Open Packet Telephony standards. Options such as Voice over IP, routed accross your fiber. You might also look to your local carriers for dark fiber already in place and take into account the overall cost of running your own fiber vs leasing dark fiber from your telco. With leasing from the telco, also consider if anything happens, its their fiber to fix. Ive seen customer installed fiber that fractures do to weather even underground. A flaw in cable you might purchase might lead to replacing sections of the fibre etc. Its not a task for the average bear. If your confident that you can get the job done or guarentees in writing from a contratr. go for it. I would expect that you could easily get your 10MBS via your fiber and more then 4 voice circuits as VOIP, VOFR have an amount of compression. Voice over Frame actualy has better utilization of its fixed frames vs. VOIP and its variable packet sizes but if you have a big pipe such as you will, it shouldnt impead. You also dont mention if your going to use single mode or multi-mode. The Multi-mode being a little more tricky.
Pete
by airforce1
by airforce1
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending