Think of a foot long cable with each end having a male 15 pin connector for, seemingly, video.
So both ends have a 15 pin connector but one end also has 3 RCA connections coming out of it as well. The 3 RCA connections are part of this cable, not added in or altered as you can see the factory look of it. Anyway, these 3 connectors, 2 definitely say left and right audio and the third says video right on it. The RCA connectors, after coming out of the molded 15 pin connector, run the length of the whole cable and are labeled left and right audio, and video. The RCA wire coverings are red, white, and yellow. So this whole thing was made for a specific purpose.
I hope this explains this a bit better. This unit was factory made, not spliced together by someone.
On one 15 pin connector it is imprinted “to video card”. On the other end, where the 15 pin and also th 3 RCA wires are, it is imprinted with the word “signal”. Also imprinted is the word “REVEAL” and this number:
10-023-007. Just under this last number is imprinted the words “R1” or possibly “RI”.
Now i know its to do with audio\video and possibly editing, but i was hoping to get more info so i can piece together this set of cables with the correct software and even missing hardware as i may have it, just dont know.
thanks