2 replies
by timwalsh
Are you having problems with what it is/does or how to calculate it?
What it is:
From www.webopedia.com - "A simple error-detection scheme in which each transmitted message is accompanied by a numerical value based on the number of set bits in the message. The receiving station then applies the same formula to the message and checks to make sure the accompanying numerical value is the same. If not, the receiver can assume that the message has been garbled."
From www.whatis.com: "A checksum is a count of the number of bits in a transmission unit that is included with the unit so that the receiver can check to see whether the same number of bits arrived. If the counts match, it's assumed that the complete transmission was received. Both TCP and UDP communication layers provide a checksum count and verification as one of their services."
The TCP and UDP protocols contain a standard algorithm to calculate a checksum for each packet. The checksum is included with the header forthe packet at the sending station. When the receiving station gets the packet, TCP or UDP independently calculates the checksum using the same algorithm. The derived checksum is compared with the checksum sent in the packet header. If they match, the packet has arrived intact. If they don't, something garbled the packet during transmission and it isn't acknowledged.
by ctu050555
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending