Networks

Ask something
Discussion Locked

Netware access through proxy

0 helpful
7 replies

by milky

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I configure Netware5.1 to go out through proxy(nt) to get the time?

7 replies

by wcraigmiles

Set a rule on the proxy server to allow requests on the SNTP port through the proxy.

Set it so anyone on the inside can make the request, don't make login and authentication a requirement. You shouldn't have to open the network for SNTP from theoutside.

Do you have the proxy set as a router and require all traffic to pass through it? If so then you can tell your NetWare server that the proxy is its default gateway.

by jimbb

Load INETCFG, select Protocols, select TCPIP, "Static Routing" should be enabled, and in "Static Route Configuration" you should set a "Default Route" to the IP address of your proxy.
This tells your NW51 server to get any IP info that is not on his own segment via that proxy.
Next you should make sure the proxy allows port 123 to be used.

This discussion is closed to new replies.