Discussion Locked

Network Freezes up a couple times a day

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Every day at least once or twice i get a call saying there are errors on the pc. So I look at the hubs and see that everything is still and nothing at all is happening, no activity. And then a minute later activity begins and we are rolling again. Any ideas why this might be happening. NT network, 30 workstations and 5 servers.

11 replies

by curacao_dejavu

it's too vague.
I would do the following.
check if all pc's and servers have the latest servicepack installed.
Check if the licensemanger if there any machines out of license.(must)
check (first) on the servers and then at the pc's if there are messages in the eventviewer.(must)
Swith the hub with another one.
Install network diagnostic tool for example observer (http://www.networkinstruments.com/)

regards,

by armour

Is it hubs you running or Switches ? If its hubs you could be overloading them Hubs just divide the bandwith evenly between everything conected and are not very eficient if more than 8 pc conected to them ( this wasnt much a problem if its only a 10mb network ) I would try a switch witch will give you imporoved performance

by sergey kovzik

if there is no activity on hubs - this is hardware problem. try to get another hubs to test. and other thing - try to find out some monitor to see requred bandwidth in your network. you can use trial version of netboy - www.ndgsoftware.com. it is possible that you overload your network and hubs are hanging by some cause.

by ryder007

You have a bottleneck my friend. I would try switching to a router system. With hubs everytime one comp sends something it goes though the entire network, as opposed to a router will only send it to the leg that the actual comp is on.

by mckaytech

A couple more questions:
During these periods of no activity, do the link lights stay up at both the hub and the PCs or servers?
Any evidence of overheating of the hub?
What are the specific errors on the PC?

paul

This discussion is closed to new replies.