Discussion Locked
0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
with 3 pc's connected on a p2p via a hub everthing is working fine.when pc's are switched off everything is lost.Although i can see pc's via find pc command , pc's are not aceessible.Please help
11 replies
by dubey_296
Hi
I think you look for properties of network neighbourhood .Is all the pcs have same workgroup define.I have also this type of problem but it got corrected when i chk my workgroup name
mail me you have more queries
by waltervw
Poster rated this answer
The first suggestion is usually a good solution for this problem but you may also run into policy problems if you have a 2k or XP box. What OS do you have on your boxes?
by waltervw
Poster rated this answer
by avswamy
make it all in same work goup and configure all ip address are in same subnet.
it is better use one system as gateway to all systems so that your configuration may not be complex.
i hope this will solve your problem
by avswamy
some times it will happens when nic is installed properly, remove/uninstall from the system and shutdown the system and physically remove the nic and reboot see for any things in device manager, if every thing is properly then reboot and install thenic.
by waltervw
Poster rated this answer
by quintar51
If you have any firewall software, try disabling it. I had a similar problem with zonealarm.
by waltervw
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies