Discussion Locked

New nic won't connect to server

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just installed a new motherboard, processor, and d link nic card into a workstation. I've got lot's of workstations (over 20)with the same mb and nic that work fine. I'm running nt4 Small Business Server with DHCP. When I have the workstation set to get ip from dhcp, the card comes up with some strange preset ip not in the dhcp server range, but when I give it a vaild network adress for my system, it won't connect to the server. I know it is seen by the server because before I changed thebrowser master setting it forced and election on the server. I can only ping the card from the workstation. I think I've got all settings the same as my other workstations. Any ideas. It's probably something simple that I'm missing. It's been a year since I've added a new machine!

8 replies

by bowieb

The strange IP address you saw is an indication that it did not receive an answer from a DHCP server when it started up. This seems to indicate that the system is not connected to the network properly. If DHCP is failing, then the problem is at a lower level than IP.

Check your cable connections and make sure that you are connected to the right hub or switch. Is the LAN card set for the right speed? Are there any routers, switches, bridges, or other equipment between this workstation andthe DHCP server? Is everything configured to work through them?

by mshavrov

Try to determin it's really NIC problem. Replace it with another one and see if it solve this problem. It may be broken NIC. When you plug it to LAN see if it has all required LED on or blinking. If this card was used somewhere else see in DHCP server it is not listed in any "hardcoded" definitions. If you have time and wish to do it you can try to use LAN Monitor to see packets with this MAC address traveling in network. And way to clear all settings is uninstall driver for this card, move it to another slot and install drivers again.

Good luck.

by cavedweller

I have seen similar problems when using a newer revision NIC than the driver supports. Try installing the latest driver from the manufacturer's support site.

by mikewbc

The answer to the problem came in the trouble shooting guide that came with a linksys nic. When you use an AMD K62 chip, you have to disable the IRQ Holder for PCI steering in the windows device manager. Once I did that, the card installed and themachine was ready to go.

This discussion is closed to new replies.