Discussion Locked

New router won't work with switches

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The business I am working for has a network based around a file server and a T1 connection used for Citrix with about 32 computers attached. They've recently decided to add cable internet connections to their network. They already had two CNet CN8020X hubs and I bought a Linksys cable/Dsl router.

The issue is that I have the cable modem and router hooked up correctly and when plugging them directly into any individual PC I get the internet connection immediately and it easily finds the IP address, BUT when I plug the router into the hub I can't get anything. No computers can find the IP address, nobody can access the internet, and the Link/Act light on the LAN side of the router just blinks and the other LAN lights don't even light up.
I've tried everything I can think of including a call to Linksys but it's not really the router with the issue it seems to be the switch or some other unknown. Thanks for the help if you can.

7 replies

by road-dog

Try hardcoding the router/switch link speed. If both are auto, sometimes autonegotiation does not work. Another layer 1-2 problem could be that your uplink port on the switch needs crossover. (not likely, but possible)

Also, check the DHCP settings on the router. The computer was getting an IP Addr from the ISP I assume. Check that the router WAN port was also.

If you are using DHCP on the LAN side (and the router is handing out addresses), Check that this is happening properly. If you are using static or DHCP on another device, make sure that the LAN port on the router is properly addressed/masked.

by madroxxx

You need to use a cross over cable or an uplink port to connect the router and the hub.

by some guy in seattle

actually, the crossover suggestion should be the correct one. A PC to a hub uses straight-through, and a hub to a router uses a straight-through. Hence, a PC to a router needs crossover.

Try using the uplink port, if you have one. Press the uplink button (or place the cable in the port that references X [crossover] versus || [straight-through]). One position or the other should produce a link light. If you don't have an uplink port, look at the ends of the cable. If the orange and green pairs are swapped, you have a crossover and it should work in a normal port from the hub to router. If they aren't swapped, get one!

Hope that helps -

by nymous

There wasn't a problem with the crossover connection, that was probably the very first thing I checked and could be changed by a simple switch on the router.

I figured out the problem about 5 minutes after I posted the question. the business hasa T1 line to link through Citrix to the main office. The problem was that our network has a router attached for that T1 line and it takes over all the IP addresses, that line can also only be changed by the main office in st. louis. The solution wasto have them configure that router to let the IP address of the Linksys router through.

This discussion is closed to new replies.