Discussion Locked

No Netware PopUp Message

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am unable to have Netware Pop Up messages come up on my PC. I am an administrator with admin rights, and I am using NT4.0 on my w/s with the Netware Client 4.8 installed. The notify block is checked in the properties of the Novell Client. Any other W/S I am logged into I get the pop up messages when printing or backups are done etc. What am I missing or that is not enabled on my PC?

Thanks KC

5 replies

by jimbb

I think "Notify" refers to notifications sent for printjobs. Check in the "Advanced Settings" tab of your client's configuration, to see if "Broadcast Mode" is set: "None" will be none, "Server Only" will be only messages like "out of disk space", "All" will include other messages, like from your backup software.

Jim

by kcamarda

You are correct, under the advanced settings/Receive Broadcast Messages, it was set to NONE. Can't believe I overlooked that. I set it to all and rebooted when prompted. Works fine.

kc

This discussion is closed to new replies.