Discussion Locked

NT 4 and large hard disks

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am setting up an NT 4 BDC that will eventually replace the current PDC. This BDC has two 40 GIG hard disks, but NT 4 reads them as 8 GIG. I plan to reinstall NT to get these reconfigured correctly, but am not sure how to go about that. Any advice is appreciated!

3 replies

by dmiles

Apperently the machines need to be updated by flashing the bios,note the bios version and manufacturer during the POST startup and go to manufacturer site for update.
Then look at the Microsoft knowledgebase and ref the download to ATAPI,which you will need to install,with service pack 6 for NT,to gain large disk support

This discussion is closed to new replies.