Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A recently promoted PDC decided to become a workstation on the network! Now the server control won't start because there is a duplicate name in the domain. The troulbe started either when I added an Intel dual network adapter or installed RAS. I promoted the BDC to Primary and the now non-connected PDC is showing as a BDC. But it thinks it's a workstation. Any ideas?
3 replies
by raffi_
I've run into similar problems with a network that also was running netbeui. Basically, only 1 NIC can bind to netbios otherwise you get the duplicate name on network error.
There is KB article on this problem.
"Q103470 - NetBIOS Name Conflicts When NetBEUI Used on Multiple NICs"
Regards
Raffi_
by goodolepop
Raffi,
Your answer was right on the mark. It was kind of a "Duh!" when I read it. I usually don't even use NetBEUI. Thanks again!
by goodolepop
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies