Networks

Ask something
Discussion Locked

NWMKDE.NLM using 219MB Ram

0 helpful
3 replies

by gadget95 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On a remote 5.1 / eDir862sp2 server, the NWMKDE.NLM module is utilizing 219Mb of memory. Has anybody seen this issue. I have tried tracking it down through TID's etc have tied it to the btrieve systems. However, on identically configured servers in other cities, this module is only using about 1.5Mb of memory. I would appreciate any leads or ideas that anybody might have on this issue.

Kevin

3 replies

by budthegrey

Look for BTI.INI (In SYS:System, I believe). This is the config file for btreive. Look for the "CacheSize" setting. It's in the [Microkernel] section, IIRC. It is the number of kilobytes of memory to allocate (i.e. CacheSize=64000 allocates 64MBof memory)

The install routine for btreive used to set this to a (usually high) percentage of whatever RAM was available at the time of installation. If you are not running any btrive based apps, you can usually turn this way down (8-16 MB)

HTH

This discussion is closed to new replies.