Question Locked

One WiFi Router, 2 IP ranges each with 2 PCs...

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was wondering if anyone could tell me if this is possible.

I have one Wifi Router which will be used as a gateway for Internet access (e.g. IP: 192.168.1.1 subet: 255.255.255.0).

There are 4 PCs for which I want to use 2 different IP ranges e.g.:

PC1 -> 192.168.1.10 subnet 255.255.255.0
PC2 -> 192.168.1.11 subnet 255.255.255.0

PC3 -> 192.168.10.10 subnet 255.255.255.0
PC4 -> 192.168.10.11 subnet 255.255.255.0

Is is possible to hook up all 4 PCs to the Wifi router and assign the Wifi router address as the default gateway??

I know this will work for PC1 and PC2.
But for PC3 and PC4 I am not sure.

Is there anything else that needs to be done on the Wifi router to accomodate PC3 and PC4, so that they can have Internet access??

Thanks in advance,

4 replies

by triathlete1981

You need to make sure the WiFi router has an IP address for the second subnet, seomthing in the 192.168.10.0 network. That should be it.

by rkuhn040172

If it's a home/SOHO type like D-Link, LinkSys, Netgear, etc probably not.

They are all going to assign the router IP to something like 192.168.0.1 or 192.168.1.1 and then limit your choices on the DHCP screen to similar.

For example, D-Link defaults to 192.168.0.1 and then on the DHCP screen limits you to 192.168.0.2-192.168.254.

by jdclyde

one for each network OR the ability to set subinterfaces, this won't work.

As was said in the last post, your SOHO/home routers will not do this.

You would need a low end Cisco or an actual router, not a cable/dsl box out of the department store.

This discussion is closed to new replies.