Discussion Locked

Point-to-point connection

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've tried to connect our corporate LAN to the sales annex with a point-to-point T1 with no luck.

I'm using Cisco 1601 router attached to Adtran CSU ACE on both ends.

What setting should I use on the Corporate router and on the annex.

The main building and annex are located around 1/4 miles apart.

9 replies

by stillatit

At each site, the inside port on the router needs to have an IP address that is in the same subnet as the computers on the local lan.

The subnet address range at each end must be different.

The WAN ports of the two routers must be on the same subnet, which must be different than either of the two offices.

If there is no internet connection at the Annex, the router inside address should be the default gateway of all machines. If there is currently an internet router there, leave the default gateways pointed at that existing router, and put a static route on that router that points traffic for the main office at the new router.

At the main office, which presumably has an internet router now, add a static route on the internet router what directs traffic for the Annex subnet to the new router (inside address).

Good luck.

by ckilday

Is your T-1 functioning properly? Do you have verified connectivity between the two sites? Is this in-house wiring or are you using a telco? You'll want to make sure you're using the same channel rate and number of channels (24 @ 64 Kbps for a full T-1) on your CSU's. One unit (master) should have internal timing and the other unit (slave) should take it's timing from the master. Your options are likely to be looped or external. If you can perform digital loopback tests between the sites,then your link and CSU's are functioning properly. Review the info provided by "Stillatit", or go to Cisco's web site and look for sample configurations for serial lines. Best wishes,
- ck

by wanabedrsean

if your only .25 miles apart you can Go to a wireless soloution if you have any line of sight with some antennas and achieve 11mb per second instead of 1.4mb ps and it would pay for itself in a few weeks compare to a t1 and 2 routers and 2 csu/dsu'sjust a suggestion not looking for a ratting but would apreciate a reply thank you. good luck

This discussion is closed to new replies.