Discussion Locked

Print job is ready and Waiting for the P

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Early this morning our NetWare 5.1 server abended. So we restarted. Now 2 out of 5 Canon ImageRunner printers are accepting print jobs but when I view the job details all it says is "Print job is ready and waiting for print server." I have rebound the print queues, recreated the objects in NWAdmin, did a factory reset and set them up again but to no avail. All I can now is TCP/IP printing is working just fine. Any ideas?

5 replies

by jose_12650

Try removing the network printer from the workstation, restart and try remapping/adding the printer again.

by pierrejamme

Not familiar with Canon printers, however I have experienced similar problems with printing to HP through IPX. I personally donot beleive print servers are meant to be run on IPX anymore, they are pushing TCIP. Personally I can hardly wait until we go pure IP!
I know you have already done this, bear with me. Using run nwadmn32 remove all the objects. Load dsrepair unattended until all errors are gone. Go back into nwadmn32 and use;
Tools
Print Service Quick Setup (NONNDPS)

and follow the order resented by nwadm32.

Hopefully this will get you going again. Good Luck

This discussion is closed to new replies.