Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have made a connection with RAS. I can browse the web. I can not browse the network or connect to any network drives or printers I am using only TCP/IP. I put the computer I want to connect to in lmhosts on the remote computer but I still cannot browse or connect to any network resorces. Can someone help?
1 reply
by rcc
If your system is NT4 : In the RAS manager, there is a setting that allows you to allow incoming clients to access the whole network or only the local host. Go to your Network Settings, go to Services, Remote Access (or Routing and Remote Access - highly recomended to upgrade to this), Properties, Network, TCP/IP - Configure: in this panel you can set the access to entire network or only the RAS host.
I hope this helps. If you refering to another OS, please post more details.
Regards,
Radu
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies