Discussion Locked

Remove "Press F10" prompt from Proliant

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Proliant 800 server that I recently installed Windows 2000 Server onto... Since the Compaq Smartstart CD I had was scratched, I installed the OS straight from the MS CD.

This has left me with no system utility partition, and every time Iboot I am prompted to "press F1 to boot, press F10 to set up system"....

Is there a way I can (without reinstalling the OS) get the utility partition on, or just remove this prompt so it will restart without halting?

7 replies

by pierrejamme

Did this several years ago with a Prosignia 300. The problem is that you need ten or eleven MB for the hidden utility partition. I did mine with Powerquest's Server Magic. D some research at the Compaq sight or even send a tech support request. It can be done, but will be labor intensive. I neede mine as I had an IRQ conflict if I remember correctly, when the integrated NIC died and I added a 3Com.

by aforjeh

I can free up space for a new partition no problem, but how do I actually install the software to it?

by adoran

Try this,

on boot, when prompted, press F9 to enter the Rom Based Setup Utility (RBSU). After entering rbsu, go to advanced, select "POST F1 Prompt" & the opotions are "disabled, delayed or On" (or something similar). If you select "Disabled" you will get rid of the F1 prompt, "delayed" means the server will sit for a few seconds waiting for an input and "On" leaves the server sitting until you hit either F1 or F10.

I don't think that you can totally get rid of the F10 prompt, just leaveit at delayed & the boot sequence carries on.

hope this is of help.

A.

This discussion is closed to new replies.