13 replies
by otwelmr Accepted solution
by robo_dev Accepted solution
got LAN link-light on cable modem?
got WAN link-light on router?
make sure you're plugged from WAN port of WRT to ethernet port on Cable modem.
in the wrt54G, can you ping the cable modem?
Have you factory-defaulted your wrt54g?
In the 'broadband status' screen of your wrt router, what IP addresses are you showing? it should show a real internet address like a 24.x.x.x or a 68.x.x.x, not a 192.x.x.x
make sure no computer is plugged into USB port of cable modem (it's either ethernet or usb, but not both).
Some cable-modem providers require you to 'clone' the registered MAC address of one PC into your router. Who is your ISP?
by otwelmr Accepted solution
I can ping the modem
I have factory defaulted the router
I will check the broadband status IP at lunch today
Nothing is plugged into the USB port
I use Charter and confirmed with them last night that they authenticate to the modem so any computer/router will work with it.
by f.ware Accepted solution
Try this tip for getting your connection back:
1. Power off everything - modem, router, and PCs
2. Reconnect the router to the modem via ethernet cable. (Of course, modem to cable outlet.)
3. Power on the modem 1st and wait for light to go green.
4. Power on the router and wait for green light.
5. Power on PC and check wireless conncetion.
The routher needs to get an IP address from the modem which is the 'gateway' on your network. This gateway will act as the DHCP for your HOST (ISP)network and assign IP address to the router, which will act as the DHCP on YOUR network and assign addresses to your PCs. Good Luck!
by tintoman Accepted solution
by dumphrey Accepted solution
power them up can matter sometimes...
Power off computer, modem and router. Power on modem first, wait till its fully up (a minute or two to allow full signal), then power up the router. Wait a few minutes. You should see activity lights on both the modem and router flicker. Finally boot up a wired host, attempt to reach internet, then try with wireless.
by jdclyde Accepted solution
power everything off.
disconnect the power and co-ax cable from the cable modem.
Wait a FEW minutes.
plug it back in.
it is not uncommon for a cable/dsl router to just die or partially die. odds are, it is your problem.
I am using one at home that we were going to throw away at work because the wireless died. still works fine for hard wired connection.
For as low as $20, you can get a new router.
http://www.tigerdirect.com/applications/category/category_slc.asp?Recs=10&Nav=|c:373|&Sort=4
by dumphrey Accepted solution
by otwelmr Accepted solution
by dumphrey Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending