Question Locked

Server was hanged and looping restart?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Our server running on window server R2 standard. recently it usualy hang at dead of night when tape backup was running. Next morning we have to restart it on ""last good known configuration"" mode. If we restart normally the restarting process would be stop during apply starting up window. after that it was restarted again.

Please help me ?

4 replies

by oh smeg

I would test the hardware first just to make sure that everything there is OK first.

You can use The Ultimate Boot CD to test your hardware with all that is required is to download the Ultimate Boot CD from here and boot off the CD that you make.

http://www.ultimatebootcd.com/download.html

Test the CPU/s, RAM and HDD to make sure that everything there is fine..

If it is as this is a server I would be inclined to reload it from scratch and restore from your Backup as this is generally speaking considerably faster than attempting to fault find within Windows.

Col

by vanbinh.nguyen

Thank for your support,

We've stopped runing your tape backup on server. Now,our server was not hanged but we have to run tape backup everyday. I think the cause of our server's problem is running Tape backup. But I don't know why is the problem issue in former times! why is it issue after the tape backup had been ran along time? Do you have any solution ?
(My english is poor)

by oh smeg

But the most obvious is that a Patch has broken the Backup Application you are using.

Try looking at the software maker and see if they have issued any new Patches or versions of the application here. Or if you are using the Windows Backup look for a Firmware update for the Tape Drive.

It's also possible that with the Tape Drive running it's drawing too much power out of the PS which has degraded over time.

Glad I could offer some ideas to follow up on.

Col

This discussion is closed to new replies.