Discussion Locked

SMC Switch

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having trouble getting an SMC 8 port switch to work on my network at home. I had a 10 base-t 8 port hub connecting my PC's, printers and linksys cable router. My PC's have 3com Fast Etherlink 10/100 cards in them. My cabling is all wired straight through. I purchased the switch and thought it would be easy to switch over to it. The ports on the switch auto detect the speed. The ports are all cross over, the same as the hub I was using. I get link lights on all of the ports that my devices are connected too. I also get a 100mbps light on my Linksys Router.

The problem is that I am unable to see anything on the network when giong through the switch. I get no internet connectivity and am unable to ping any device on the network.

I spoke with SMC and they said the switch must be bad. They sent me out a new one but it is doing the same thing.

Any help would be greatly appreciated.

7 replies

by mckaytech

I almost hate to suggest that your second switch is also bad, but you really should be able to just un-plug the hub, plug in the switch and have everything work just fine.

The only thing I could suggest would be to put just two devices on the switch, configure the NIC cards with explicit settings (e.g. 10meg half-duplex) rather than auto-negotiate, and then try pinging.
If it works then, you've got an auto-negotiation problem and you'll probably be okay if just configure the NICs with explicit settings.

If it still won't work, I think I'd give up on SMC switches because it shouldn't be like birthing a camel to install a simple switch.

paul

by khall

Thanks for the info. I still can't get it to work. I have tried about everything I can think of.

by daveseng

Make sure that you've got a cross-over connection between the switch and the LinkSys (which is technically a hub).

Can you unplug the LinkSys and then successfully ping amongst the devices connected to the switch? The answer to this question will isolate the fault domain.....if you can ping then the problem is with the switch to hub communication (see question #1 above) If you can't then the problem lies within the switch.

by mike o

Unfortunately I've had a similar problem. We had a 16 port switch and two 8 port switches, all SMC. We could not get half the computers to talk to one another. Ultimately we swapped them for 10/100 hubs instead of switches and they worked like a champ. There just must be something about SMC switches that makes them a pain in the butt...

This discussion is closed to new replies.