Question Locked

The Last Bit - Enable RDP To My Home Network

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I think that I'm nearly there. I've bought, base-lined and created a domain on my server. I've purchased a static IP address and have the associated sub-net mask, DNS1, DNS2 etc...

I'm really not sure what to do to enable RDP from outside of my home network. I have a reasonably good Linksys router. I've been doing some reading up about it but:...

1. How would I set-up/configure port forwarding?
2. Would I configure my router with the static IP information provided and if so how would I point any incoming traffic to my domain controller?
3. What sort of Firewall do I need? Should I buy one or is it built into the router?
4. Any security considerations, I've looked into VPN's and I understand that they're more secure but I have to be able to connect to this environment from virtually anywhere and as RDP comes as standard I would prefer to utilize it in the first instance.

Any advice/links would be greatly appreciated.

5 replies

by seanferd

Port forwarding - configure in the router (see router docs, or poke around in the router, you'll find it). Default port for Remote desktop is 3389, so you'd open that port in the router and any software firewall for remote desktop.

http://www.portforward.com/

http://www.google.com/search?q=RDP+port

The router should have a firewall, but most folks will suggest a software firewall for your computer. You can use the Windows firewall, but others are better. Try Online Armor (free or paid) http://tallemu.com/

http://www.windowsecurity.com/articles/Configure-VPN-Connection-Windows-XP.html

A static IP from your ISP would be set on the router. No ideas about the DC, not really my fort?. If you are setting static IPs behind the router on the computers, you turn off DHCP in the router & computers and assign these addresses.

by seanferd

Glad to hear it.
And thanks for the thumb.

Enjoy!

by asalive

Your router would get the static IP that was assigned to you, and your DC will look to the router to get that information.

In a LAN setting your router would be the gateway that your DC assigns to the computer within the domain. So in this situation your Domain Controller would have an IP from your LAN. Your routers LAN address will be the gateway for all of your computers to get to the internet. you will use port forwarding to route external traffic to the necessary machines.

Your should have to ability to set both a LAN address and WAN (static IP from the ISP) address.

This discussion is closed to new replies.