Discussion Locked

Using MRTG for 95th percentile

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are using MRTG for calculating the 95th percentile based bandwidth calculation for our own internal analysis.

Since we apply this at the port level(Switch port), i would like to know how much of actual internet INTERNET bandwidth our server isconsuming and it should no include server to server LAN traffic

2 replies

by mckaytech

Without knowing what your hardware is (what SNMP MIBs are available, etc.) and what your network layout is like, it would be difficult to offer a useful answer.

MRTG simply queries SNMP counters and reports the results so what you need to figure out is how to isolate the Internet traffic from your server at a certain point and then use the correct SNMP counter at that point. That is probably going to have be done at a router rather than a switch.

paul

by vinniv

U R right Paul, we need to use it at the router level, bt i was particularly interested in knowing what Cisco MIB's i need query to bring about this report. Since I also use HP Openview with CW2K at my backend and I have integrated it with MRTG, butat the Switch level - plz help me find the right MIBs

This discussion is closed to new replies.