Yes I have the following hardware now but still can’t route between two Vlans or PC does not get IP from the DHCP server(Router).
Both Vlans should be active since I have Router.
2950 12 port Switch
2651 Router duel ethernet ports
Netgear ADSL DG834PN Router
Connected:
Router 0/0 port – ADSL Router
Router 0/1 port – Trunk port of switch(f0/1)
PC – normal switch port
Followed the link below and Configured Router as DHCP server. If you want I can post “sh run” output from the Router.
Router 0/0: connected to ADSL router to get IP from ISP
Router 0/1: 10.65.194.1 255.255.254.0
Switch:
VLAN 1: 10.65.195.2 255.255.254.0
VLAN 2: 10.65.196.2 255.255.254.0
http://networking-newbie.blogspot.com/2008/10/configure-cisco-router-to-work-with_18.html