Networks

Ask something
Discussion Locked

volume not mounting

0 helpful
3 replies

by mdjameer

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i use netware 3.12 .when my server start there is massege volume not mounting i try to vrepair .but there is messge no volume to repair .i scan harddisk for virus .no virus found.what could be the reasen?

3 replies

by budthegrey

If the volume does not mount, and VREPAR can't find it, then something in the disk channel has gone bad; there is a problem with either the controller ,or perhaps the disk has failed. Do the drivers for the disk controller load?

by rogerndgreen

First of all, do your disk drivers load correctly?
You don't say if they are IDE or SCSI?
Are you using DSK or HAM drivers?
I assume that you have got all the last patches on the server?
If you are using DSK drivers, try manually loading them from the DOS partition - the server will attempt to use the obvious ports/IRQs that it can see.
If you are using HAM drivers, have you loaded IDEHD.CDM (for IDE disks) or SCSIHD.CDM (for SCSI disks) as well as the appropriate HAM driver?
You need to give more info than this for more specific advice

This discussion is closed to new replies.