Discussion Locked

VPN on NT 4.0

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been trying to get a VPN setup in my company. I have a Win 4.0 sp 5 server with 2 nic's and Proxy Server running. I have installed RAS and PPTP, set the Proxy to recieve and call PPTP and have insalled VPN on Win 98 system. Have set VPN to the external Card and enabled IP forwarding. While inside the company I can cancle my log in to the network and using DUN/VPN can connect. Outside the company I keep getting the server is not answering or will not accept this type of connection. I haveread several articles, checked my configurations and settings and still cannot figure out why I cannot connect.
Any thoughts?

4 replies

by stillatit

1. Do you have RAS installed, or RRAS (you need RRAS)?

2. Unless you have a good reason not to upgrade to sp6a, upgrade.

3. The load order of RRAS and Proxy and service packs is critical. See the knowledge base article at
http://support.microsoft.com/support/kb/articles/Q183/5/37.ASP
(no spaces in that url)
for details. If you did not load everything exactly correctly you can spend weeks pulling out your hair. The way you load stuff determines where in the protocol stack each product places its hooks. For example, if Proxy sees outside things first (normal), it had better allow port 1723 to come into the rest of the stack so that RRAS can get it.

4. From bitter experiance I can tell you that patching does not work. If it is notinstalled right, the only solution is to yank both proxy and RRAS out and reinstall exactly according to the directions.

5. If everything is installed right, make sure that Proxy lets in and out port 1723. That is the main difference between getting in from inside and outside.

Good luck.

by firebrwd

So I guess I am working this weekend to redo the server. Thank you for your input and help

by firebrwd

Just have to ask as I don't want to do this and then have to do it again. In the article yo sent me one of the steps is to install a Unix communication piece. If I have no Unix on my network this step I can skip right?

This discussion is closed to new replies.