Question Locked

Want to setup a mirror between two hard drives?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to setup a mirror data set between two hard drives on a server box. I am using ServeRaid Manager to perform this tasks.

Here is a little bit of information -

On the right hand side, I have "Physical devices"
- Controller 1 (SATA HostRaid)
- Port 0..1 (2 Devices found)
- Port 0 - Partitioned
- Port 1 - Hot Spare

How can I create a mirror between these two hard drives?

I am using IBM ServeRaid Manager v7.00.15

Do provide me with suggestions or ways on how I can accomplish this tasks.

3 replies

by churdoo

I don't know enough about IBM ServeRAID to give pointers. The important thing is, if I understand correctly, that it sounds like you may already have a working system / data on one of the drives. If so, you will have to proceed in a way such that the controller knows this and it mirrors the one populated drive onto the other instead of creating a blank array. Because of this risk, I would call an IBM ServeRAID tech.

Otherwise, if the server is not set up yet and you can indeed create a blank array, then usually in the context of the Controller, you create the array, or you create a group of disks (JBOD) and then carve the array out of the JBOD.

Hope this helps.

by nishi57

...I do have data on the hard drives. However I want to setup it for as a backup and as a future fail safe. As if one server fails, I can still use the data from the other hard drive and start the data migration process without loosing much time.

This discussion is closed to new replies.