2 replies
by Member 27131101 Accepted solution
by robo_dev Accepted solution
Assuming that your FW Router is connected to the Internet, and not a corporate WAN, then the helper addresses would be needed on the L3 switches. Not sure where your SSG320 is installed in your network.
Helper addresses are used to forward things that are typically broadcast protocols (e.g. ARP, DHCP, NetBios) across subnets, which normally does not happen in a routed network.
Typically these are needed in an enterprise WAN when DHCP servers may be too far away. In this scenario, they would be needed on the edge router/firewall at each remote site.
On the local network with several VLANs, helper addresses are used so that dumb protocols like Microsoft Networking can work...otherwise nothing works if your domain controller or WINS server is on another subnet.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending