Discussion Locked

why won't my network talk at 100 Mbs?

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Windows 2000 Advanced server connected to a portable Windows 98 machine with a crossover cable. Both have 10/100 cards. Connection speed is always 10 Mbs. How can I get 100 Mbs?

14 replies

by mckaytech

You'll probably have to explicitly configure the cards for 100/full-duplex. Auto-negotiation often doesn't work in this context.

pal

by bleone

I can't find any dialog to configure the pc card. The card in the server I have set to full duplex.

by mckaytech

If you can re-post with the make and model of the 10/100 card in the portable, I can probably help you find a way to get to the configuration settings. With some cards, there is a command-line utility you have to run because the driver doesn't expose that part to the Adapter tab on the Networks properties page.

paul

by big ray

Replace the cable. If the cable has any excess bends or is not cat5 compliant you may have problems getting the full throughput. You could also try getting a 10/100 hub and see if both PC's connect to the hub at 100. If they do then you know it was the crossover cable that had the problem.

by kevin anderson

There's probably a DOS config utility for the NICs which will allow you to specify the speed. Use that. Once you hard set the speeds, you should be fine.

Kev.

by ebob

"pmwright" 's first answer is the best answer. Why did you "reject" it?

BTW, although it seems a small pojnt, the correct identifier for the speed is "Mbps". Why do I care? Beacsue one of these days, if it hasn't happened already, there is going to be some problem with little slips like this.

by jb14808

The First Answer IS correct. But if we have to be as precise as I will try to be with this answer there is something VERY lacking.

Try this...
Right click My network places and choose "Open."
Choose the appropriate Adapter, right click and select properties...

In the "Network Adapter Properties" window, Click Configure....
Then click the Advanced tab.
The properties of your cards that can be changed will be listed in a pane on the left side of the window. Select the option that most closely matches some form of "Speed" or "Connection type" You'll notice a drop down list on the right side of the window. It may very well be set at "auto" or "Auto-sense" if it is, set it to 100MbpsFULL DUPLEX or the equivalent. Do the exact same thing on the other workstation adjusting the commands for the particular NIC installed, and your machines will communicate at
100 Mega Bits per Second.

Hope that's what you're after.

by jb14808

I just realized you did not request FUll Duplex. My answer will allow data transfer at 200Mbps so I'll amend it thus.

Set the drop down menu to 100Mbps not 100MbpsFULLDUPLEX and you'll acheive the throughput you desire.

This discussion is closed to new replies.