5 replies
by dsessions Accepted solution
by churdoo Accepted solution
If so ...
First thing to do is to call the vendor that wrote those specs and give them hell for suggesting a 5GB system vol for W2K3. I mean, puh-LEASE!
Next, (assuming full backup is in place) take your 3 146-giggers, and ONE at a time, replace the 36-giggers with the 146GB drives, leaving time, and verifying that the array is completely rebuilt and optimal before each swap.
Once the last drive is swapped in and array rebuilt, you should be able to EXTEND the array to take up the now total disk space.
Finally, purchase Acronis Disk Director and re-partition the volumes and re-create the DR baseline.
by dsessions Accepted solution
by churdoo Accepted solution
First, to "Not having done this before I must have messed up, cause the system couldn't find a boot drive",
this probably had to do with array ordering or the selection of boot array; a phone call to Dell support probably could have resolved that without having to resort to backups.
As for the downtime of the method that I've suggested, if your server has hot-swap drives, the only down time would be to run the Acronis re-partitioning, which would only be a matter of minutes to hours.
by dsessions Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending