Question Locked

2 DSL routers on one network

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

It is possible to have two DSL routers on 1 network?

The reason I ask is that I wish to split mail server and webserver for incoming requests, but still have fast access to them both from within the network without having to go via the internet.

If both routers are on the same subnet, should this work?

Or could they be on different subnet such as 192.168.0.0 and 192.168.1.0 and use subnet mask of 255.255.0.0 and still be able to map ports - sat port 80 to 192.168.0.2 and port 25 to 192.168.1.2

6 replies

by hal 9000

Instigate the routers. If they are both on the one Server you can run them independently and then set SN to what you need after the Routers are setup.

If they are to go on different computers it then depends on how you have things setup as to how you would go about configuring there 2 Routers.

Col

by islandcomputers

Thanks for reply - this is what I have done so far

Local Address
Router 1 : 192.168.7.1 DHCP : ADSL connection
Mail Server : 192.168.7.2 - Windows XP
Router 2 : 192.168.7.3 (not DHCP) : ADSL connection
Web Server : 192.168.7.8 - Ubuntu Server

Router 1 will access both servers with HTTP, POP3, SMTP - ie everything
Router 2 will access mail server with SMTP (25) and POP3 (110) - but not with HTTP

Router 2 can ping both servers (and any other computer on network)

Both routers are Netgear DG834 (with VPN on Router 1)

Both Frimware V3.01.25

I need mail to come in on router 2 - http on router 1 & 2

Computers on network can access both Router 1 & Router 2

Any ideas what could be wrong? It is almost what I need

by hal 9000

Your descriptions has a contradiction in it as shown here

[i]Router 2 will access mail server with SMTP (25) and POP3 (110) - but not with HTTP[/i]

& then you state something quite different here

[i]I need mail to come in on router 2 - http on router 1 & 2[/i]

Is this right? Or it is just a Typo?

Col

by cg it

that you have 2 networks. So computers behind 1 will have to go through the WAN link on the other to gain access.

therefore you need to setup remote access.

by islandcomputers

This ic correct

mail in ou Router 2

Http on Router 1 & Router 2 - to balance the load!

This discussion is closed to new replies.