Networks

Ask something
Discussion Locked

3com NIC

0 helpful
3 replies

by itpro128

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We installed 3com 10/100mbps NIC card to IBM P1 machines which already has 10Mbps inbuild.But we still receive 10Mbps output despite we use 100Mbps capable Cisco Switch?What could be our problem??

3 replies

by lmon

Right click on the 3com card select properties. You should get the Properties screen. In the "general tab" select configure (make sure the card is the 3comm card) then go to the "advacned" and check the link speed\duplex mode it should be on "Auto mode" but can be changed to whatever you want. If that does not change anything and you have a manageable switch I would check the switches settings to see if they are at 10Mbps or 100 Mbps.

This discussion is closed to new replies.