Discussion Locked

Active Directory Issues

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are just setting up a network.I installed Active Directory on a Win2k Advanced Server using Terminal Services.After reboot, I cant login cos of a so called Time lag b/w client and Server.
Note:I installed AD on the server from another system, using Terminal Services.Pls I need an answer ASAP.

11 replies

by d.walker5

I suspect there is a time difference between the Client and Server. To resolve this problem click START, RUN, type CMD and click OK. At the command prompt type something similar to the following:NET TIME /DOMAIN:name /SET

Where "name" is the domain name being used by the computer. If you are not certain what the domain name should be replace name with "%userdomain%" without the quotes.

If the problem persists, reject this answer, and give full info from the Event Viewer. Include Event IDand Source.

by ned2

d.walker, thanks.But I can't login to the system.I cant go beyond the login page cos of the error.It says it's a Time lag b/w Client and Server.So I cant implement ur solution without logging in.

by gregross

If there is a time issue between the client and you are running win2kpro or XP. setup the windows time service to point to the DC.
open up command prompt
net stop w32time

net time /setsntp:(servername)

net start w32time

This will ensure that you are synched up with the dc.
If this doesn't work it is likely not a time issue.

by d.walker5

The battery that maintains the time in CMOS, when you computer is shut down, may be bad or going bad. Contact your Admin (Help Desk)for support. The error is a Kerberos Logon error that can only be fixed by sinking your nodes' time clock with the server. Other solutions may include NTLM logon, but the Admin will need to made this change on the DC. The KDC may be experiencing problems, but other users would be unable to log on.

by ric111

As a side note, MS recommends against putting Terminal Server on a Domain Controller. By default TS clients cannot address a DC.

This discussion is closed to new replies.