Question Locked

Active directory on home network

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Heres a brief overview of my situation.

I'm trying to learn AD..

On a partition of my computer I created a domain on server 2003. I then used virtual pc to create two clients.

Now on my normal partition I connect to my router using dhcp. The IP address(gateway) for my router is 192.168.1.1

I set up DNS on my Active directory. My statically assigned IP address and my dns are both 10.1.1.1 Now when I use "nslookup anthony.local" on the command prompt it does point to my server and the 10.1.1.1.

I configured my two clients with other addresses on the 10.1.1.x subnet. And they all see eachother.

I'm able to replicate my AD to a client on virtual PC so im pretty sure I did it all right. But I need to be able to get online..

What am I missing? Or what would be as more easier way for me to set this up, and at the same time still learn how to configure AD?

5 replies

by p.j.hutchison

On your DNS server, you can configure Forwarding by specifying the IP address of your router, see DNS management console. Then clients can still use the domain and access the internet as well.

by xrenx215

Thanks...I tried playing around with it, with no luck

Basically heres what I have in there

Forwarding
server01.anthony.local [10.1.1.1]

Reverse lookup
10.1.1.x subnet
with a pointer to 10.1.1.1

I'm not sure what or where to add it in my forwarding. Again I am learning this, so any additional suggestions would be greatly welcome.

by p.j.hutchison

The problem is that your router address is on a different subnet from your internal network. You need to either change the ip addres of your router from 192.168.x.x to a 10.x.x.x address for it to work or change the ip addresses your computers in your AD domain.

by xrenx215

Thanks, Thats actually what I did over the weekend.

I set my router to 192.168.1.254

My Host server pc to 192.168.1.1
(for some reason my fwd/ and reverse pointers were real adamant about my server being the x.x.x.1

I set the virtual pc clients to 192.168.1.3 amd 192.168.1.4

I left my dns server at 192.168.1.1
and my gateway obviously to 192.168.1.254.

Thank you very much for taking the time to give me advice.

This discussion is closed to new replies.