Question Locked

Adaptec 2940 UW Problems with Windows XP

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On boot-up the controller recognizes the harddrive but when Xp boots, I only see the IDE drives

3 replies

by thechas

I find it very interesting that Adaptec does not have Windows XP drivers posted for this card.

I suspect that the default drivers included with XP should work for this card.

Have you configured the SCSI drive(s)?
You need to configure SCSI drives before you can use them.

Here is a link to the Adaptec manual for your card.

http://download.adaptec.com/pdfs/installation_guides/aha2940v220_ig.pdf

Also, make sure the controller shows up properly in device manager. You may need to install the driver again to get it working. You also may need to get an update for the XP driver from Microsoft.

Chas

by mposis

Go to Control Panel->Administrative Tools->Computer Management->Storage Management->Disk Management. There you can see the drives. Right click on them to create partitions.

This discussion is closed to new replies.