IBM has very little information about these older PCs on their website.
You say it is a Pentium 133.
If so, the memory is likely 72 pin SIMMs.
These need to be installed in matched pairs, and all 4 SIMMs must be of the same style.
(FPM, Parity, EDO)
Since you have 16MB, and all 4 sockets have memory in them, you likely have 4 4MB SIMMs.
I suspect that your motherboard can handle either 8MB, or 16MB, and may be able to use 32MB SIMMs.
Non-parity FPM SIMMs should work.
However, some of these boards required EDO SIMMs.
Your sources for SIMM memory are very limited.
Try www.crucial.com
www.compgeeks.com
www.computersurplusoutlet.com
www.pcliquidators.com
On a per MB basis, SIMM memory is much more expensive than DIMM memory.
It may be cheaper to buy a used PII or Super socker 7 PC than to upgrade this PC.
Removal:
At each end of the memory module you should see a small metal catch that holds the memory into the socket.
NOTE: If you do not see the catches, it is possible that the memory is actually soldered to the board.
If so, then you CANNOT add memory.
To remove a SIMM, push both metal tabs outwards, and help / allow the SIMM to tilt away from the catches.
To install a new SIMM, orient the notchin the end of the SIMM properly.
Slide the SIMM into the socket at an angle.
Tilt the SIMM up, align the 2 pins on the socket with the holes on each end of the SIMM, and lock the SIMM into the catches.
Chas