Discussion Locked

Adding A Sharp Copier as A Printer

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The Sharp Copier dealer gave me a program called IP-P2P and said it was the networking software for this copier.(although the copyright is 1998!). I installed it on an XP workstation, and an IP-P2P port is a selection in "add a port", but when you try to go further, you get an error message "Specified Port Cannot Be Added." I thought his might be a permissions issue, but I have full administrator rights. I can ping the assigned address on the copier. Can anyone assist?

1 reply

by cptomlly

Windows 2000/XP support direct LPR port printing to IP address without software. This software was likely written to give the IP printing capability to Win9x. Can you install just the drivers for the printer/copier w/o the IP-P2P software?

If you can, then just run the "add printer wizard". Select local printer, uncheck "PnP detection" and click next. Then select "Create a new port" and select "Standard TCP/IP port", and click next. This will launch Std. TCP/IP port wizard. All you should have to do is enter the IP address (you can change the port name if you want), and it will attempt to configure the port automatically.

Hope this helps.

This discussion is closed to new replies.