Discussion Locked

Administering Netware servers

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We are running several servers in 5 different locations which run novell netware 3.12. How can I assign these servers an IP address and be able to remotely administer them without one having to physically move to that location to work on them?

3 replies

by idesh_beba

Which OS do you have on your WKS?
If it is win9x or w2k you should have novell client 32 installed an run ZEN remote administrator. Of course you have modem on each server or client which is logged as supervisor.
If you have DOS WS install PC Anywhere 5.0 on WKS and login as supervisor.
Ivo Huljev

by soylantgreen

If you're using that old a version of NW, stick w/ NWADMIN if you can. In order to "assign those servers an IP address" you gotta have IP installed as a service on the server itself. They use IPX/SPX by default, not TCP/IP, remember?

by jimbb

ZENworks and NWadmin cannot be used for NW3.12 at all.
First of all, you can remotely control every Novell server via sys:\public\rconsole.exe. Requirements: (1) IPX and SPX between you and the server - which is kind of obvious for NW312. (2) A few modules loaded on the server:
LOAD REMOTE
LOAD RSPX
Of course you can use your own password for , and this password is what you'll need to fill in when using rconsole.

Then... IP for NW312... It's been a bit long for me(NW4.11 and NW5.0 are no longer supported - NW3.x is almost prehistoric), but I'm not sure if IP was supported out of the box. Products like UNIX-connectivity or NetwareIP provided IP support, as far as I remember.
And if not, let's see if I can crawl back in time far enough.
-LOAD TCPIP
-LOAD FRAME=ETHERNET_II NAME=
-BIND IP TO ADDRESS=aa.bb.cc.dd MASK=ff.gg.hh.ii

I guess you understood that aa.bb... is the IP-address, and ff.gg... theSubnet Mask. But again, I'm not at all sure if IP was supported without additional products.

Don't forget to put all the required commands in autoexec.ncf.

Jim

This discussion is closed to new replies.