Question Locked

Advice/help needed with routing between subnets

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 subnets: 192.168.1.0/24 and 192.168.20.0/24. I'd like to join the subnets. The .20 network already has a router with an interface that will accept traffic bound for this network. The .1 network has a Cisco PIX 506e, which has a single inside and single outside interface. I tried adding a static route on the inside interface to the .20 network, but it didn't work. I suspect I need either a) a router with a 3rd interface or b) create sub-interfaces on the PIX. As I am not too familiar with creating the sub-interfaces, I was thinking of a 3rd option: create static routes on the 2 windows PC's that will be accessing the .20 network. It is only these PC's that will access the .20 network, so maybe this is the easiest/cheapest option? Thanx for any help..

3 replies

by robo_dev

I'm not sure subinterfaces is a good idea on a pix anyway.

by kbreiner

That's what I figured. It looks like I'd also have to create a VLAN on my switch along with a sub-if on the pix, which I could do, but it seems to complicate things.

Is the Windows command line switch '-p' enough to make the route persistent, or should I make a login script just to be sure?

This discussion is closed to new replies.