Question Locked

AGP Graphics Card In K8M800 MoBo

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Im trying to install a Radeon X1300 Graphics card (agp) Into my Motherboard ( K8M80-M7A )

When the monitor is plugged into the Card instead of the MoBo, I get the message "no signal input", but when its in the Mobo it works fine.

Device manager fails to even realise that i have soemthing IN the AGP slot.

I have already disabled onboard graphics in Bios, and uninstalled and removed all the onboard software and hardware.

I thought maybe i was missing a jumper and just had to switch it, but there arent any jumpers aside from the Bios Reset, and the 2 USB port jumpers.

What Am I missing? (Im Running Windows XP Home, 2GB of DDR2 667 Ram, on a AMD Athlong 64 x2 2.4 ghz CPU)

Please and thank you :\

3 replies

by thumbsup2

Are you absolutely certain the card works? Have you tried it in another machine?

Often, cards simply need to be reseated or simply seated properly to begin with. Those of us who have been around for years used to say that "if you're thumbs aren't bleeding, the card isn't seated properly". So, try this....

First, try pulling the card out and reseating it, making sure it snaps all the way down into the slot and catches the catch thingie at the rear of the card. While booting, go into BIOS and disable the MoBo onboard video and make sure the video settings are set to use AGP as first choice for video, not auto, save changes and exit. It will reboot. Windows should detect it if the card is actually working and snapped into place correctly.

If that doesn't work, shut down and pull the card back out and hook up to MoBo video, boot up and go into device manager. Disable the graphics in there (will result in a red x on it). Then shut down, put AGP card back in making sure it snaps down into place good (push hard), hook up monitor to it and turn computer on.

by j-e-allen

Well the problem wasnt my card, it was the motherboard itself. There is a defect in the agp slot on the mobo and it doesnt work. Which is why the card is getting power, but the monitor wont get a signal when its plugged in.

Ive decided to go with a Dual PCI E mobo instead so i can crossfire when i have the money. Thanks for the help and, btw, I had already disabled the onboard video in bios, turned it to read agp first, even turned of memory sharing to hard shutdown the onboard video card. Which is why I came here to ask for help.

And yes i had tried any combination you can name of inserting graphics card, installing drivers, and praying that i just missed part of the process in the previous attempts.

Again, thank you for the help, and hopefully the mobo i get this time round wont have any glitches XD

-Jake

This discussion is closed to new replies.