Question Locked

As a consultant or tech?

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How much would you charge to Research (Correct speed & Type),Buy, and install RAM?

12 replies

by jamesrl

Whats your time worth?

Its been decades since I've done it for a living, but I would be charging for about 30 minutes of time, depending on travel etc.

James

by snuffy09

I?m a Higher end Tech by trade. I just do some independent work evenings and weekends.

Thank you for your fast post

by jamesrl

30 minutes at minimum $40 an hour....

James

by older mycroft

Probably 30 minutes.

As for the research and purchase, you might care to instruct the user how to perform that themselves as an online check using that system. You might improve your image with them by including this 'education'.

Great oaks from little acorns etc etc.

by snuffy09

if i pay 30 for the stick of memory and install it for them charge like $50?

by jamesrl

Discount it if you get to do more than one or two - like upgrading 10 PCs at one time.

James

by oh smeg

Actually getting the RAM that you are adding. Naturally if you buy lots of it and you don't have to travel far to get it then it's not costing you as much in wasted time to get. But if you have to travel 1 hour each way and are only buying 1 or 2 sticks at a time it's costing you more in Time per Stick.

I don't even consider researching what is required as Chargeable as this you should already know or at the very least be able to find out very quickly. But all things being equal and no outrageous traveling costs involved I charge around the $20 to $25 mark just to fit RAM and set the system to work with it or if they are a friend who I owe I don't bother charging for the Labor as I'm already making a profit on the RAM. ;)

Of course if I had to drive more than 15 minutes both ways that is a different story but if they bring it to me with warning so that I have the required bits it's not costing me anything to do so anything I charge is all profit.

Col

by oh smeg

I had one guy bring me a Monitor that needed a New Data Lead well the Plug actually so to help me they brought a Plug along with the Shell to mount it in and then offered to help me solder on the New Plug.

I will not make any mention that I had a Data Lead for this Monitor and offered to give it to them free and fit it as well. No they wanted me to show them how to solder on the Wires so I stripped the plug down and soldered the Wires to the newly supplied plug. No I didn't cut my fingers stripping the plug off but I most certainly did burn my fingers several times soldering the wires onto the Plug. If I had of left them longer there would have been no problems but then again the lead would have looked messy and had the Internal Wires hanging out of the Plug.

Anyway after I had finished and had it working they said Thanks now I'll have that new Data Lead fitted. It was at that time that the costs went up dramatically and I asked for $4,000,000.00 for the remainder of the work. ;)

Col

This discussion is closed to new replies.