Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have constant power failures, how can I set my Server 2003 to automatically shut down once the power fails and before the UPS runs out?
2 replies
by johan Accepted solution
Clarifications
by bart777 Accepted solution
The UPS that you have should have a cable and software to connect to the server.
The cable can be USB, Serial, or ethernet depending on type.
You will connect this to the server and then install the rivers for the device or if it has it's own software you will install that. then it's just a matter of configuring the power down based on what it gets from the UPS.
Best of luck
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies