Discussion Locked

Bad NT 4.0 Install

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello TechRep members,
I work at a local technical college in the tech support dept. and I've got an NT situation that's about to drive me crazy. Even our NT subject matter expert is somewhat boggled about this one. During an install one of the staff here at work was unable to complete an NT install on a brand new machine. When attempting to do so he receives an error: One or more of hard disks has more than 1024 cylinders. It also goes on to say: Unable to locate the hard disk partitionprepared by MS-DOS at setup. Any suggestions are welcome and many thanks in advance!!!

9 replies

by maxwell edison

One common cause of the subject error is that you created new setup floppies but didn't use the WINNT /OX command.

Running WINNT without the /OX switch, cause WINNT.SIF to be placed onto diskette 2 of the 3 diskette setup disk set. The WINNT.SIF file contains:

[Data]
MsDosInitiated = 1

which tells setup to look for the installation files on a temporary directory of the hard disk.

To fix the problem, do any of the following:

- Edit the WINNT.SIF file and change MsDosInitiated = 1to MsDosInitiated = 0.

- Delete the WINNT.SIF file.

- Discard the diskettes and run WINNT /OX from the CD-ROM.

Maxwell

by curacao_dejavu

If the server supports a bootable cd, use that feature and install via the cdrom.
Else create the floppies with the winnt/ox command.
If the harddisk is greater and 8 GB, you will also receive the error message: ... 1024 cylinders.(reason: nt supports 8GB only after installation of sp4.)so install nt and when done install sp6a.
Simply continue the installation, delete the existing partition if nessary and create a new one for the error message :Unable to locate the hard disk partition prepared by MS-DOS at setup.

Leopold

by ann777

Q110695:
During Windows NT Setup, just after Setup restarts your computer, the following error message may appear:

Setup is unable to locate the hard drive partition prepared by the MS-DOS portion of setup.

Setup (WINNT.EXE) by default places temporary files on the first available drive with enough free space, but because WINNT.EXE can see drives that Windows NT may or may not support, sometimes these temporary files become inaccessible to Setup. (Unsupported drives may be compressed drives, unsupported SCSI drives, or drives on secondary IDE or ESDI controllers.)

To work around this problem, use the /T switch with the WINNT command. The /T switch specifies the target drive to which temporary files will be stored by Setup.

by miss kitty

When I install 4.0, I run fdisk from the boot disk and delete any old partitions and create new ones. Then I reformat the C: drive and do the install. Good luck
Cathy
covcat@riverstonegrp.com

This discussion is closed to new replies.