Question Locked

Bad or missing command Interpreter

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to boot from a CD using the Super Fdisk bootable software. I have written the ISO to a CD and when I try to boot from the CD I get the following error:

Bad or missing command interpreter: 8 - /P /E:256

Please enter the correct location (for example c:\command.com):

I realize that it is looking for a mounting point to find the command.com command interpreter but any drive I put in to for the PC to mount returns the same error. All I need is to foramt my drive. The drive is not found when I try to re-install Vists or if I try to install fedora. The HD is recognized in my BIOS but i cant seem to get any tools to reformat the HD. Please help...thanks!!!

4 replies

by rob miners

1. Burn the Ptd.iso Image file to a CD. The ISO file you download is an Image of a bootable CD. It must be burned as an Image to a CD and not simply burned to the CD as a file. You will need a completely blank writable CD.

2. If you cannot boot from the bootable CD, please use another CD-ROM to boot or use another CDR (CD-RW) disk to burn the bootable CD, because someCD-ROM or CDR (CD-RW) disks have inherent errors.

http://www.ptdd.com/bootablecd.htm

by the scummy one

the drive is going out. If the controller board talks to the BIOS and says I Am Here, the BIOS will show it, however, if the motor is dead/dying, it may not function well enough to be 'seen' by the OS.

Try this, in the BIOS is there any tools to test the HDD? If so, try to test it. What are the results?

If it tests ok, then try creating just a Windows boot cd (bootdisk.com) and see if it will allow you to either format or partition/format the drive.

by seanferd

There is probably some other issue if the interpreter is not found by the boot image, but the path would be:

[CD Drive letter]:\command.com

You can see this if you look on the disk, or look into the saved ISO image itself. It is possible your download is corrupted.

As mentioned in the other posts, your HDD might be near death. For kicks, have you disconnected the drive, booted the system, shut down, reconnected, booted?

This discussion is closed to new replies.