Discussion Locked

Bandwidth Monitoring and Capping

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to give Internet access Bandwidth to 10 Peoples and want to give monitoring to them like MRTG or else but I have only 7 Interface vacant on my router including Serial interface and fastethernet interface. I have cisco 2900 XL switch, Cisco 3600 Series Router. Is it possible that I can cap the bandwidth on switch or using cheapest equipment so that I can configure MRTG on that interface.
Is there any possibilty that I can manage my network with less expense. I don't want to install router or windows 2000 server with SNMP enabled on it as I want to give bandwidth on CAT 5 Cable through fast ethernet interface.
Is it possible that I can use one Ethernet interface and with subnetting or else I can give connectivity to all peoples through Cisco switch and configure any monitoring tool on it and cap the bandwidth.

2 replies

by v.prakash

This can be done, the following way.
1.Your router(3600 series) should have an IOS version of "IP plus", or should be upgraded to one.(ask your vendor.)
2.ONce you did this, your router fast ethernet could be divided into many number of sub interfaces(virtually) and each can be configured for each of the ten people you wish to allocate.
3.You can run MRTG for each of the sub interfaces.
4.Now how you physically give is, connect the router fast ethernet port to your switch and from the switch distribute it to the 10 people.
some configuration needs to be done in the switch.
Each of the sub-interface you created in the fast ethernet port of your router can be restricted bandwidthwise using "rate-limit".

by v.prakash

if your router does not have enough memory to support this higher IOS(12.1 and above) u can load a tftp server(which will have this IOS) in a PC and boot the router by giving that path reference.

This discussion is closed to new replies.