Question Locked

Belkin DSL Modem Router & Belkin N1 Wireless Router

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm configuring the DSL Modem wireless Router & the N1 wireless router to work together. Somehow, I'm unable to setup the wireless router to access the internet thru the DSL Modem Router.

I've connected the wireless router 'Modem' port to the DSL modem router port 1 by Cable. I tried many settings but failed to do so. Both of them the default internal IP is 192.168.2.1. Once I changed the internal IP of the wireless router and off the DHCP, I'm unable to access the wireless router again. Eventhough I can get connected the wireless router, but just limited or no connectivity.

I found the WAN IP in the wireless router is 192.168.2.8, I suppose this is assigned by the DSL modem router. I have even tried the 'wireless bridge' but the DSL modem couldn't start the connectivity for the wireless router itself.

Is there any experts out there can help me with this?I just want to extend the router numbers for more people can access.

4 replies

by internetspider

Reset you Modem and start from the beginning
Goto command prompt type ipconfig

it will show you the Access IP address.Setup your modem by information provided by your service provider.

About the No connectivity or limited connectivity it will solve itself if you wait little more time otherwise you can enter IP address manually
Goto Control Panel> Network connections> right click on Local Area Connection> Properties> select TCP/IP> Properties> select Use the following ip address> enter ip address of Modem subnet + gateway.

Post for more...

by faraz.karamat

After spending countless hours this is how I was able to make my DSL and Wifi Router to share internet:

Don't change anything on the DSL Config
Don't Change anything on the Router Config
Network Cable from DSL is supposed to go into Router Internet port... but this will not work! HAH! so instead insert this cable in one of the network (LAN) ports on your router. Your client PCs will recognize a new device on the network and everything should get configured automatically... assuming you are using Win XP SP2.

Hope this helps... oh also after you complete the above mentioned steps restart both DSL Modem and and router if needed.

Best Regards,
Faraz J Karamat
Mandala Technologies (http://www.mandala-tech.com)

by ashay0286

The configuration worked for me but I changed the ip address of the wireless router to 192.168.2.1 because when the router automatically configured it maintained the 192.168.1.1 address which conflicted with the DSL modem and it worked just fine.

This discussion is closed to new replies.